I know this is a very specific problem but not sure if it happens on other touch screens or if anyone can help
I am using a 3M Microtouch Touch screen for a project and if SYSTEMPOINTER is TRUE then it works totally fine on either windowed or full screen, the pointer follows my finger and the x,y debug output I have is spot on. If I turn the SYSTEMPOINTER to FALSE then the returned x,y values are all over the place. I can start in the bottom right of a 1024x768 screen and move my finger no more than 3mm towards the top left and the x,y is reported as 0,0. Infact most of the time the x is either 0 or 1024 and y is 0 or 768. It never reports the correct value. Yet if I move the mouse around the x,y shows correctly in my debug with the pointer off.
Any suggestions?
Thanks
Gary
I am using a 3M Microtouch Touch screen for a project and if SYSTEMPOINTER is TRUE then it works totally fine on either windowed or full screen, the pointer follows my finger and the x,y debug output I have is spot on. If I turn the SYSTEMPOINTER to FALSE then the returned x,y values are all over the place. I can start in the bottom right of a 1024x768 screen and move my finger no more than 3mm towards the top left and the x,y is reported as 0,0. Infact most of the time the x is either 0 or 1024 and y is 0 or 768. It never reports the correct value. Yet if I move the mouse around the x,y shows correctly in my debug with the pointer off.
Any suggestions?
Thanks
Gary